Ask Experts Questions for FREE Help !
Ask
    christiebeecher's Avatar
    christiebeecher Posts: 9, Reputation: 4
    New Member
    		  
    #1

    Feb 26, 2009, 03:11 PM
    Can't break threaded coupler loose, under kitchen sink.
    I am trying to replace the faucet in my kitchen. Circa 1960 something. The water line in is 1/2 inch copper w/ a threaded end, then a brass coupler that takes it from half inch to quarter inch. I'd like to remove that threaded coupler but I can't seem to break it loose. Any suggestions would be appreciated. Thanks for your help,
    Christie
    Ps space is quite tight so longer levers are not an option
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Feb 26, 2009, 03:22 PM
    Have you tried heating the connection? If the threads show any evidence of water leakage, the connection may be seized to the point that the male adapter would have to be cut off the copper line and replaced. Good luck.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Feb 26, 2009, 05:22 PM

    A basin wrench is used by most of us in this tight spot. You can get them at ACE for about $7. https://www.hardwareworld.com/11in-B...h-pN7NTI2.aspx
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Relocating Sink Drain/Vent to Dedicated Stack Serving Kitchen Sink & Dishwasher [ 3 Answers ]

I am relocating an upstairs vanity sink from one wall to another (also going from single to double bowl). Rather than relocate the drain and vent pipe, I am hoping that I can tie into a 1-1/2" copper vent pipe that is located right behind the vanities intended location. The copper vent pipe is from...

Loose one handle faucet on kitchen sink [ 6 Answers ]

How would I fix my kitchen faucet it is very loose on the sink - still works fine - but I know this can't be good for it. It is a one handle with spray diverter. It didn't just gradually get loose - just one day it was like that. I need something like 'anatomy of a faucet' - as I have no clue...

Fog horn noise when using taps in bathroom sink and kitchen sink [ 1 Answers ]

There has developed, in the last week, a "fog horn" sound when we turn on the hot or cold taps in the bathroom or kitchen. It does not occur when we use the washer or dishwasher. Could anyone give some advise on what could be the cause of this?

New shower valve has threaded unions, old one has non-threaded soldered supply lines [ 2 Answers ]

I bought a new bath/shower two handle 8" spaced valve unit. It has threaded supply unions, but the supply lines are not threaded. What do I need to convert the lines? Can I install stop valve and flexible lines to the threaded valve body hot/cold connections?

Kitchen Sink/Laundry Sink Drain Vent Non-exist [ 3 Answers ]

The set-up from kitchen sink leading down to drain to basement: 1. Kitchen sink - (R side) - connected to a P drain I think you call it -PVC-, connected to a "metal" T, which has a Studer vent gizmo attached to the top of it, then draining into a metal pipe straight down to the drain in the...

View more questions Search