Ask Experts Questions for FREE Help !
Ask
    billmerrill's Avatar
    billmerrill Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 25, 2009, 12:31 PM
    Pilot won't stay lit
    I have two empire wall heaters.One works fine the other the pilot won't stay lit.I have switched the thermopile or flame reader on them to see if that's the problem and its still the same the one that worked still works with the thermopile from the other and the one that didn't work still doesn't with the other thermopile from the one that dose.Could it be the valve.
    Thanks
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Feb 25, 2009, 12:58 PM
    It could be a dirty or short pilot on the defective unit. It could also be the gas valve. See below link
    Attached Images
  1. File Type: pdf Doc1.pdf (143.7 KB, 172 views)

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My pilot light won't stay lit [ 6 Answers ]

Help,I have two problems.. My upstairs furnace pilot light will light,and after holding down the pilot button for about 3-4 minutes(it says one minute,but it won't stay lit after only one)it stays,but will go out again in a day or two... The furnace for the downstairs won't light at all.. I can't...

Gas furnace pilot won't stay lit [ 1 Answers ]

About 1 month ago pilo light wouldn't stay lit so I replaced the thermocouple.. The unit worked fine for about 2 weeks. After that when relighting it would go out after 1 day or so. Bought a new thermocouple and this one would only keep the pilot lit for 1 to 2 hours. Reinstalled the thermocouple I...

Pilot light won't stay lit [ 1 Answers ]

Why does the pilot light on my hot water heater go out after about 10 minutes of being lit?

Pilot light won't stay lit [ 2 Answers ]

I have a Bryant Heater on upstairs ofmy central unit. I can light my pilot light and the unit will start heating. The it shuts off. The fan continues to blow and the heater still works, but the pilot light goes out and has to be re-lit. Is that the thermocouple? I have a Bryant 394had036050...

Pilot won't stay on [ 3 Answers ]

I have a snyder-general furnace and my pilot won't stay on after you turn it from pilot to on I tried evrything... is it the thermocouple or does this furnace have a sensor... and if so how do I change it out... furnace was manufacture in 91...


View more questions Search