Ask Experts Questions for FREE Help !
Ask
    stevenjani's Avatar
    stevenjani Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 21, 2009, 02:36 PM
    Moen shower mixing valve
    Can I take apart and rebuild a moen shower mixing valve without replumbing
    firefighterlong's Avatar
    firefighterlong Posts: 7, Reputation: 2
    New Member
    		  
    #2

    Feb 21, 2009, 08:23 PM
    Depending on the model, it should have a cartridge or inserts, so yes you should be able to rebuild vs replumbing.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Supporting shower mixing valve when using PEX [ 4 Answers ]

Can someone provide a few tips for how you support a shower mixing valve in the wall when you've used PEX? On previous showers that I've put in, the copper pipes strapped to a block in the wall was more than enough. This time I can't quite seem to find a decent way to do this. Thanks.

Shower mixing valve leak [ 2 Answers ]

I am buying a home and during the inspection of the bathroom we noticed that water pours out of the mixing valve for the shower. I was wondering if this requires replacement of the mixing valve or can be repaired in some other way? Can this be done by a do it yourselfer with no plumbing...

Shower mixing valve [ 4 Answers ]

I have two bthrooms back to back, and all fixtures have ample hot water except one shower mixing valve. It is a temptrol valve. I have replaced the stem twice, replace the seats, cut the water lines in the basement to see if there was a blockage in the piping but cannot seem to find the problem....

Mixing valve/shower arm [ 2 Answers ]

:cool: Is it possible to install a shower/tub mixing valve on a different wall then the shower arm? We are getting a new house built and if this were possible it would save us a lot of grief... Thanks Doug

Mixing valve tub/shower with no cold water [ 1 Answers ]

I'm flummoxed with a Delta, mid-1990's mixing valve. The valve has shut-off's via screw and locknut on cold and hot inlets, and I have good pressure there at both hot and cold side. But an inch-or-so away, at the main body holding the cartridge (I don't know the terminology, sorry), no cold...

View more questions Search