Ask Experts Questions for FREE Help !
Ask
    ntcarson's Avatar
    ntcarson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 21, 2006, 09:40 PM
    Replaced shower drain
    Hi,

    I just cut a hole in my ceiling and replaced the shower drain. I used a plumber's putty on the top and locked in the washer on the bottom. Should I have used sealant at any spot on the install, or is the putty sufficient? After a day or so, I was able to tighten the nut more; is there something that I should do to ensure that it stays locked in? Should I do something to better secure the base of the shower around the drain?

    Thanks,

    ntcarson
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Aug 22, 2006, 07:08 AM
    Quote Originally Posted by ntcarson
    Hi,

    I just cut a hole in my ceiling and replaced the shower drain. I used a plumber's putty on the top and locked in the washer on the bottom. Should I have used sealant at any spot on the install, or is the putty sufficient? After a day or so, I was able to tighten the nut more; is there something that I should do to ensure that it stays locked in? Should I do something to better secure the base of the shower around the drain?

    Thanks,

    ntcarson
    You have done everything that could be done. The putty's what seals the drain, no other sealant's necessary. Good job! Regards, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replaced Shower valve problem [ 2 Answers ]

This SHOULD have been simple... I replaced HOT and COLD valves and the DIVERTER on 2 showers. They were old and needed to go. Great care was taken to match and get the proper replacements. The COLD on each shower works well. The HOT leaks out the center post a bit in each shower. The...

Shower was leaking from handles/I replaced and now it won't work [ 2 Answers ]

I purchased a replacement kit for a shower with leaking handles. I made sure to buy the same bonnets and seats. I changed everything out. Now it does not work at all. No water comes out of the shower head. The diverter does not leak at all but the water comes out of the shower handles only. I...

Replaced faucet and drain in bathroom, LEAK! [ 4 Answers ]

Hi there, I replaced the faucet in my bathroom and it seems to be working OK, however I am getting a leak when I run the water on full blast. The leak is coming from the joint between the drain that came with the faucet and the curved pvc joint that connects to the straight pipe that goes into...

Replaced Main Water Line, Now Shower Line Is Clogged [ 3 Answers ]

We had a leak, so we had the water line and sewage line from the house to the street replaced. Now we have no water in the shower. Some debris most have clogged up the line coming into the shower. All the other lines are fine. My Dad is somewhat of a handyman and wants to fix the problem...

Converting cast iron floor drain to shower drain [ 3 Answers ]

I am adding a bathroom to my basement, which has partial (complete? ) plumbing already roughed into the floor (in 1976). Sewage lift station (vented) is 3 ft from 4" styrofoam plug (toilet), 4 ft from 1 1/2 inch cast male pipe end extending through floor (lav, have already added vertical vent...

View more questions Search