Ask Experts Questions for FREE Help !
Ask
    jehsec's Avatar
    jehsec Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 15, 2009, 11:25 AM
    Thermostat/fan running
    I tried to install a new Honeywell Programmable Thermostat. When everything was connected the fan for my unit stated running. It has not shut off even when I put the old thermostat back in place. Can anyone help?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Feb 15, 2009, 12:12 PM

    Going to need some more info. Does the fan shut off when thermostat wires are disconnected? Try unhooking thermostat wires at control on furnace and see if blower still runs. IF thermostat wires are unhooked at furnace board, and the blower still runs, then you have a problem in furnace, but if blower shuts off when wires are disconnected, then it is a problem in thermostat or thermostat wiring. Please let me know more about this and I will try to help.
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #3

    Feb 15, 2009, 02:02 PM
    Sounds like the circuit board has a blown low-voltage fuse.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #4

    Feb 16, 2009, 05:24 PM

    Kc13 makes a good point. You may have blown the fuse while wiring the new thermostat. Locate fuse and check. Please let us know if you find it.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heat keeps running even after thermostat turned down or off. [ 3 Answers ]

For a couple of winters now, my furnace will not turn off all the time when I turn the thermostat down or it will just keep running forever above the set termostat temperature. The airconditioner works fine with the thermostat. The thermostat was replaced last year to see if that would solve the...

Hunter digital thermostat 44860 fan keeps running [ 1 Answers ]

We have electrical heating/air. Have self installed hunter 44860 and programmed. When we return power, the fan will not cut off. We have set it up for "refresh" 15 minutes.

How to get a bryant thermostat running again [ 2 Answers ]

I have a digital thermostat bryant and the screen went blank how do I fix it its for a air conditioner

Running Fan Manually from Thermostat [ 1 Answers ]

I have an Intertherm model MMHB-070ABHR gas furnace. I am replacing the old mechanical thermostat which did not have a fan on switch with a digital thermostat. The wiring to the thermostat now has only 2 wires. Which wire on the furnace do I wire to so that I can use the fan control on the...

Bath tub shower spout & head running water running at same time [ 1 Answers ]

I started with a slight dripping problem(sayko system).i decided to replace all 3 stem assemblies together as they all were about 18 years old.after reassembling the new stems(danko brand),turned on the water supply & checked faucets.hot & cold worked fine but when the shower was turned on,water...


View more questions Search