Ask Experts Questions for FREE Help !
Ask
    Sticky Sam's Avatar
    Sticky Sam Posts: 76, Reputation: -2
    Junior Member
     
    #1

    Feb 3, 2009, 07:14 PM
    Briggs & Stratton Quantum XTE handle broken.
    The push handle tube ( the bit with the throttle and cables ) has broken where it bolts onto the lower tube. Unfortunately the part of the tube with the bolt holes is missing I thought about brazing and drilling another piece of tube to the bottom of the push handle. It does not have to look pretty, just work. I have never done brazing before, is this possible/worth it ?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Feb 3, 2009, 08:47 PM

    Post a pic.

    Brazing/silver soldering is an art. It takes some practice.
    If you don't have a lot of things in the way then a simple Turbo Torch that attaches to a MAPP gas cylinder, the right flux and silver solder and your set.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs & Stratton 16.5 OHV [ 19 Answers ]

I have a B&S 16.5 OHV MTD Yardman that will not turn over even though the starter and battery are OK. It will turn to a point and then stops. If I remove the spark plug it turns freely like it should. I know that removes the pressure in the cylinder but I don't know what could cause it to bind...

4.5 briggs & stratton [ 3 Answers ]

My lawn mower starts & revs up and down on a full tank,and when almost empty runs well!

Broken exhaust valve in 14.5 Briggs and Stratton [ 1 Answers ]

Exhaust valve broke on my murray. Nothing appears to be harmed, only one little ding in top of head where it hit. Can I just replace it with a new one or will it have to be lapped in at a machine shop to work right. Also, what are the valve clearance settings on a Briggs 14.5 with overhead valves.

Briggs and Stratton 10 hp [ 1 Answers ]

Can some one help me I need to know what valve setting to set on my briggs stratton generator. Thank you for you help

Briggs&Stratton Billy Goat Pull Start broken [ 3 Answers ]

Hey, my billy goat pull start is stuffed. When I pull it it goes floppy and won't wind back onto the wheel. Its happened before but when I've taken the top plate off it wound back on and I hadn't had trouble with it, until now. Is there anything I can do ?:confused:


View more questions Search