Ask Experts Questions for FREE Help !
Ask
    mac1369's Avatar
    mac1369 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 1, 2009, 10:58 PM
    Furnace does not egnight
    My furnace will not egnight the gas. The fan turns on but I do not havae heat. Is it OK to keep the furnace on or shoule I turn it off for fear of having a CO2 problem??
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
    		  
    #2

    Feb 1, 2009, 11:23 PM

    Is this a standing pilot light one that you need to light or is the furnace electronic lighting?
    I posted a site on hot water heaters that show a typical gas valve. They are basically the same for a furnace. See if there are lighting instructions on the inside metal cover you pull off the furnace to give you lighting instructions if it's a pilot light

    http://www.youtube.com/watch?v=pAOqlUMhlFQ

    http://www.youtube.com/watch?v=Wky7l...eature=related

    http://www.youtube.com/watch?v=xGQng...eature=related

    Signed 21 Boat

    If I Helped To Answer Your Question Please Rate My Answer
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Furnace ignites but blower won't start till furnace shuts down. [ 7 Answers ]

(Nordyne/Miller G3RA)-I have a furnace HSI(glow plug) that will ignite and burn until it gets too hot and shuts down. As soon as the furnace shuts down the blower starts to circulate air. The blower circulating air cools the furnace and it reignites.Shortly after the furnace ignites the blower...

Furnace not heating the house. Damper on the furnace not opening. Motor then shuts. [ 4 Answers ]

My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad:

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

View more questions Search