 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Hi BV120...
Yes, Cast iron and PVC can "marry" each other as long as you purchase a cast iron x pvc SHIELDED CLAMP (picture on left). Do not use the all rubber coupling with two SS clamps (pic. On right). These are not intended for your project. Common names for shielded clamps include proflex clamps or mission clamps. They are usually available at home depot or Lowe's type stores. If not available at these stores in your area then they can definitely be found at a local plumbing supply company. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Help! I'm remodeling the bath and would like to change the layout. Current Layout:Toilet and bath on east wall w/ 3" DWV stack. Single bowl vanity on west wall with 2" DWV stack. Desired Layout: On the west wall I'd like to make the vanity a double bowl and move the toilet to the west wall....
I'm in the middle of a bathroom reno (combining a small bathroom and small laundry room to make one big bathroom) and want to move the toilet over 4 feet so it's not in the middle of the room. It's an 80 yr old house with a cast iron waste line, galvanized supply line and steel vent out the roof...
How difficult is it to move a toilet 6 inches to the left so as to install a jaccuzzi tub. How do I move a toilet?
We are remodeling our bathroom. We are putting in a larger tub/shower combo and it might be tight with existing toilet location. We have a crawl space under bathroom so, I wasn't sure how hard or costly this might be.
Hello - I am in the process of a major bathroom remodel. The bathroom is almost exactly 10X10 and I am swapping the shower and toilet locations (they are currently in opposite corners of the room). Draining/Venting the shower will not be an issue as I can tap into the same 2 inch drain pipe. The...
View more questions Search
|
