Ask Experts Questions for FREE Help !
Ask
    rsjudd1385's Avatar
    rsjudd1385 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 26, 2009, 05:20 PM
    Trouble code 33
    My bryant gas furnace will run for about 5min. The shut off flashing a 33 code
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jan 26, 2009, 05:23 PM
    Look on inside of the door/cover should tell you whar code 33 means
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #3

    Jan 26, 2009, 06:27 PM
    33-limit fault. How's the air filter?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honda won't Start - Trouble Code 19 [ 3 Answers ]

My 95 Honda Civic ate its timing belt... I pulled it into the garage and proceeded to dismantle everything needed to change the belt. Followed Haynes manual. I replaced seals, belts, valve cover gasket, spark-plug tube o-rings, well, the works. I made sure that when the crankshaft pulley key was...

1990 Honda CRX Code 16 is giving me trouble [ 4 Answers ]

My Honda was giving me code 15 and code 16. I've managed to eliminate code 15 and now code 16 just won't go away. My vehicle sounds fine and idles normal. It just suddenly dies sparaticly. Can anyone help me diagnose?

92-95 civic trouble code retreival problem, please help [ 7 Answers ]

My 95 civic died mysteriously the other day. The coil appears to be bad. I replaced the coil, and still no spark. I tried to check trouble codes, but when the 2-pin green connector is shorted, and key turned on, the check engine light comes on and stays on always.. . Then the SRS light starts...

91 Civic no start/Trouble code 15 [ 3 Answers ]

Ok, Things that have been changed out with new parts, the Main Relay, The complete Distributor. Fuel pump and all of the Fuses Grounds and wireing has been checked. I am getting a trouble code 15 indicitave of a no signal from Distributor. All of the wiring seems fine, have any of you run into...


View more questions Search