Ask Experts Questions for FREE Help !
Ask
    Codyl8808's Avatar
    Codyl8808 Posts: 3, Reputation: 1
    New Member
     
    #1

    Jan 20, 2009, 10:24 AM
    My honda maxs at 3100 rpms
    Ok so I drive a 2001 honda civic lx, may be a mistake :mad:
    I was driving down the road one day and it just died.
    I pulled over and it started right back up.
    But now when I give it gas, when the rpms reach 3100 it maxs out
    And starts to jerk, almost like a rev limiter,
    What can cause that?
    The check engine light is on.

    If you have an answer it would be greatly appreciated if you answer or please email me
    At [email protected]
    this8384's Avatar
    this8384 Posts: 4,564, Reputation: 485
    Ultra Member
     
    #2

    Jan 20, 2009, 10:56 AM

    Have a scan done to determine which codes are stored in the computer. Post them here and we'll go from there.

    When you say it maxes out at 3100rpm, is that with the vehicle in park?
    Codyl8808's Avatar
    Codyl8808 Posts: 3, Reputation: 1
    New Member
     
    #3

    Jan 20, 2009, 09:21 PM
    No I mean like after I've been driving for about ten minutes (car runs fine at first)
    It starts jerkin and sounds like a rev at 3100 while driving, I have tolet go of the gas a little bit and then let it shift. When I took it to auto zone the diagnostics test said mass airflow sensor, map sensor, ecm, or bad connection. I have changed the mass airflow sensor and that did nothing, I am willing to change the other things but need to know what people think is wrong with it first, because the ecm is $500.
    Thanks for helping:)
    this8384's Avatar
    this8384 Posts: 4,564, Reputation: 485
    Ultra Member
     
    #4

    Jan 21, 2009, 07:46 AM

    What codes did they give you specifically? Auto Zoners are notorious for trying to diagnose vehicles past their knowledge; I had a customer get told he needed a fuel injector because his truck was putting out the code for lean fuel trim. When he pointed out that his truck wasn't skipping or missing, she actually started arguing with him and told him that she knew that was what he needed... which of course, it wasn't.

    Get the code number; it'll make everything easier.
    Codyl8808's Avatar
    Codyl8808 Posts: 3, Reputation: 1
    New Member
     
    #5

    Jan 22, 2009, 08:24 PM

    OK I will get the codes and get backtou tomorrow. Thanks

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to setup Hp Laserjet 3100 on xp [ 3 Answers ]

I am looking for a driver for Hp Laserjet 3100. I have the disk that came with the printer but it doesn't work with xp. Thanks for your help!:)

Hp laserjet 3100 installation disk [ 1 Answers ]

This is my first time doing this. I have a laserjet 3100 printer with copier, fax and scan. I have no disk to install to another computer with Windows XP. On this computer I have Windows Millennium. Can you please help me please?:confused:

92 honda RPMs drop lost of power [ 1 Answers ]

While the car is driving the RPMs and THe speedometer drop and the clock dims. If I turn off the car it won't start anymore. It will later start but after park for long time

2000 Honda Civic EX suddenly idles at low rpms [ 1 Answers ]

I have a honda civic ex that suddenly idles at low rpms. I just replaced the spark plugs but it still idles at low rpms. Please try and help.

Honda Civic 2001 RPMs drop rough idle [ 1 Answers ]

This problem has been bothering me for a while and I have tried a few basic things such as replacing plugs, air filter, and I tried checking the EGR with the "pinch" test because I had read that may cause this problem. But, I got the clicking sound, which supposedly means it is working. When I...


View more questions Search