Ask Experts Questions for FREE Help !
Ask
    jjill's Avatar
    jjill Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 21, 2009, 09:45 AM
    Insulating existing return air duct
    I have a return air duct that travels through the outside wall of my home and gets so cold that when it runs under the wood floor turning to the furnace, the floor is also ice cold. I am sure this is making my heater work too hard.

    I have heard that blocking the return air can hurt the system (I do know which room this comes from and I have returns in each room). But would this be better than frigid return air in the heater?

    I have also seen that you can insulate the ducts. Does this involve tearing out the drywall to add insulation behind the duct? And will this really help for all of the work that is involved in doing that? Is there a way to add insulation without destruction?

    Thanks.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 21, 2009, 01:46 PM
    Do NOT block the return air unless you install a new return air of the same size or bigger somewhere else in the room or home. Blocking it can cause major problems.

    Usually you have to tear out the wall to get to the duct. The easy way out is to install a new return air in a different location and eliminate the other.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installing a heat duct in existing basement wall [ 3 Answers ]

I need tips to install a 6x10 heat duct in a wall. I have installed a wood burner and want to vent one of the heat runs into a large family room. The family room side is finished, the back of the wall is in my mechanical room and unfinished.

Replace 5 ton with a 4 ton AC; keep existing duct work [ 3 Answers ]

I have to install a new air conditioning unit. The old one is dead (Heil 60LC-000087CR; a 5 ton machine manufactured in 1991) Two contractors have bid to replace it (Trane 13 SEER and a Lennox 14 SEER). Both have recommended 5 ton machines. However on this site and other literature - proper...

Loud Return Air Duct [ 1 Answers ]

I have a forced hot air furnace, installed in September 2002, located in the basement. The blower motor is belt driven, single speed. While the blower is running it you can hear it all over the house. The return air grill is located out side of a bedroom and during the night when the blower comes...

Return Air Duct [ 3 Answers ]

I rent a townhome. It has 2 air conditioning units. I don't know what brand they are. The upstairs does not cool very well. It is always warmer than downstairs. The return air unit is in the storage closed downstairs. There are 2 return air ducts. The one downstairs was covered up behind...

Wiring duct fans to my existing furnace [ 2 Answers ]

Hello all. This is my first post on these here forums :) I have been searching on the internet for weeks without success. I have a Goodman B18099-13 Control Board on my furnace. I've installed multiple duct fans in my duct work in order to increase the airflow through my wall/floor...


View more questions Search