Ask Experts Questions for FREE Help !
Ask
    louisglenda's Avatar
    louisglenda Posts: 36, Reputation: 3
    Junior Member
    		  
    #1

    Jan 17, 2009, 11:18 AM
    Gas boiler vent how close?
    Oh doesn't know I am asking
    We are putting up an awning/veranda roof and have a calor gas boiler . How close could we go to the outside vent and can anyone recommend a suitable heatproof material for the edges of the awning. He is not planning to go close to it but I would like it to be near it??
    Rivethead's Avatar
    Rivethead Posts: 88, Reputation: 7
    Junior Member
    		  
    #2

    Jan 17, 2009, 04:50 PM

    Your vent is located where. Extending out of the side wall?
    louisglenda's Avatar
    louisglenda Posts: 36, Reputation: 3
    Junior Member
    		  
    #3

    Jan 18, 2009, 05:49 AM
    Hi The vent is on the back wall to the right of the back door. The canopy will cover some of the back door and I would like to have it covering all of it but don't know how close we can go to the vent.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I insulate an oil boiler exhaust vent? [ 5 Answers ]

I have an oil fueled boiler in a lower level with a 30' run of an 8" exhaust through a crawl space to the chimney. The temperature of the exhaust near the boiler is 700F and it drops to 250F near the chimney. I would like to insulate it with something to reduce the temperature drop so that the...

B Vent too close to framing? [ 3 Answers ]

I recently had a new gas furnace installed (Carrier 58CVA090 Variable Speed Gas Furnace) and at that time the installers replaced the old exhaust vent with B Vent (this is the term they used). They also ran the exhaust from the gas hot water heater into this same vent. The vent goes thorough a...

Boiler air vent [ 1 Answers ]

I'm installing another zone to my force hot water (baseboard) boiler. The initial installation has a shutoff valve and plug on supply and return so extra zones can be installed. On other multizone houses, I've noticed that each extra zone has an automatic air bleed valve on the high point of the...

Gas line & dryer vent pipe - how close is too close? [ 1 Answers ]

I'm rerouting the gas dryer vent piping so that it will inside the adjoining stud wall. At the top of the wall the vertical exhaust pipe will be within an inch or two of the horizontal running copper gas supply line. Question - is there a minimum distance that the metal dryer exhaust pipe must...

View more questions Search