Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Stuck middle valve - 3 handle shower valve
 [ 3 Answers ]
 Help and suggestions!! The middle handle, used to divert water from the tub spout to shower head is stuck in the 'tub' position. I have removed the handle and trim bezel and tried to turn the shaft with pliers - no luck & quit before marring the splines on the brass shaft. What now?? 
Shower valve
 [ 5 Answers ]
 Hello I recently installed a bath tub in my basement. I installed ½” tee’s into the already existing ½” pex that was in the house for the hot and cold water and ran them over to the water valve via ½ pex since that’s what was used for everything else in the house. My problem is that there is a... 
Replace shower Plumbing Valve assembly shower head 2 knobs
 [ 3 Answers ]
 In a fiberglass corner shower shell. What I have is an old leaking rusted Shower valve assembly. It leaks from the Shower head that is a hand sprayer with a wall mount from the sprayer. It also leaks around the both the hot and cold water wall mount knobs. The cold water knob the sleeve that... 
Shower mix valve
 [ 1 Answers ]
 Hello, I have a one valve tub hot water / shower mixer. You pull it out to get water out of faucet and than lift a deverter thing (similar to a sink drain closer_ to get the water to come out of the shower. The faucet is dripping . I believe it is the rubber end of the stem inside the valve. I... 
Shower valve
 [ 3 Answers ]
 
Tom, how are you doing? Can you explain all of the differences to me between a thermostatic water valve and a pressure regulated valve, and which one would be the best to use for my new shower for temp. control. I want to avoid those WOWs when someone turns on water somewhere else in the house.... View more questions Search 
  |