Ask Experts Questions for FREE Help !
Ask
    amaurino's Avatar
    amaurino Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 11, 2009, 05:36 PM
    My gas furnace ignites and then goes out
    Hi Guys,
    I have a gas fired luxaire furnace that's about 5 years old and when it calls for heat the element lights, the burners lite and then they go out in about 3 seconds the led flashes 7 times. Any sugestions?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 11, 2009, 05:56 PM
    Try this
    Attached Images
     
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
     
    #3

    Jan 11, 2009, 06:04 PM

    There it is! Those nickels adding up?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace ignites then shuts down [ 3 Answers ]

When my Goodman furnace (CWP#00299785) turns on, the blower works and the burners ignite, but after a few seconds the burners extinguish. Then the burners ignite again for a few seconds and extinguish once again. Please tell me what part(s) I need and where those parts are located on the furnace....

Furnace burner ignites, but no fan operation [ 10 Answers ]

I went to finally turn on the heat for the first time and while it took a minute or 2 for the vent motor and burners to ignite, the main fan never started up. The fan does work with the AC, but does not work when I switch the fan to "on" at the thermostat. Could it be the integrated Furnace...

Furnace ignites but blower won't start till furnace shuts down. [ 7 Answers ]

(Nordyne/Miller G3RA)-I have a furnace HSI(glow plug) that will ignite and burn until it gets too hot and shuts down. As soon as the furnace shuts down the blower starts to circulate air. The blower circulating air cools the furnace and it reignites.Shortly after the furnace ignites the blower...

Gas furnace ignites intermittently-ignites after removing cover from ignitor chamber [ 3 Answers ]

Unit: Carrier WeatherMaker 9200 gas furnace, with an HSI ignitor Symptom 1: Thermostat is calling for heat, as evidenced by a flame icon on thermostat face, but no action in the furnace. Symptom 2: Ignites only AFTER I initiate Action 2 below. Then it seems to work for a while, until the...

3A fuse blowing after furnace ignites [ 5 Answers ]

'Working on a 10-yr old Goodman GMP050-3. A/C is okay, but no heat. Circuit board and ignitor were just replaced and the flame sensor has been cleaned. The unit comes on, status light solid, ignitor glows, gas comes on and ignites, but after 2-3 seconds the 3A fuse on the board blows.


View more questions Search