Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Installing Floor Registers to Draw Basement Heat
[ 7 Answers ]
I have a 2-story colonial in CT. The heating system for the house is oil-fired (forced hot air). A couple of years ago, I finished the basement and made it a den. Since there was no heat in the basement, I installed a propane heater made for rooms - the one I installed (a Rinnai) is actually rated...
Using attic air for supplemental heat.
[ 3 Answers ]
Recently I had to vent my bathroom fan properly (previous home owner vented it to the attic). Obviously it was much warmer up there and I was wondering if I could install a fan in my house to pull warm attic air into a common living area. I know attic air has a lot of moisture be we also use a...
Installation of heat pump in attic
[ 1 Answers ]
Location: STANHOPE, NJ Current system : Heat : Oil Boiler (30 years old) with water pipe running in the walls Provide also hot water to the house Cool : 3 wall mounted SANYO with pump outside (12 years old) Objective The current system is old an $$$ to operate. Sometime we...
Heat in Attic/Garage
[ 3 Answers ]
I have a newly constructed home - single floor on a slab with an attached double car garage at one end and an attic that runs the full length and width of the house. The home was built with 6 attic vents in the roof just below the very top of the roof line. They are circular and I'm guessing about... View more questions Search
|