 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace not blowing
In my electric Coleman furnace I can see the orange glow at the bottom... The motor is moving.. I can see it in the squirrel box up top. But the heat is sitting in the vents and not blowing anywhere... What part should I go buy? It's a newer furnace but I have no manual with it.
|
||||
|
||||
|
If the motor is moving the correct amount of air there should be no problems
Check to make sure all return vents are open. Check air filter and replace if dirty. Make sure both supply and returns are open. Your blower motor might not be operating correctly causing the problem |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hello, I am visiting my uncle and his natural gas furnace is not working for forced air heating. There is hot water in the house, but I cannot get heat. I replaced the thermostat and can't even get the blower to operate in ON, never mind AUTO. He says it has been very temperamental lately where...
Hello, I have a Payne model #PY1PNB036090ABAA serial#1603G20727 propane gas pack. I had just replaced the sensor, control board and the control module. The exterior unit lights now and even worked for about a week. But now it blows air without heat and has a smokey odor. Thank you Karla
I have a intertherm Central Electric furnace Model FEW-015H Voltage supply 240 volts Heating output 53,000BTUH Appliance No.F000551240.It is only throwing out warm air.It run all of the time to heat the trailer up.Before husband died it threw out hot air and took no time to warm trailer up.
Please HELP!! I am a single mother of 2 and I have a problem. My thermostate is set at 72 degrees. The house temp is at 71 and the sound of the burner can be heard as if the furnace will kick out hot air any minute. Yet, the fan does not come on and start blowing air through the vents. What...
Carrier Furnace. My furnace blower stays on after shutdown. Keep getting a code 33 which says flame rollout switch is open. How do I bypass them or tell if they are bad? Had control board replaced afew months ago. If I let the system sit a couple of hours, it will usually reset. Please help.
View more questions Search
|
