Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Does putting gas hot water heater dial on PILOT put pilot light out?
[ 5 Answers ]
My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...
Lennox Ignition Pilot Control Module
[ 3 Answers ]
My problem with my Lennox furnace (model G23Q-3/4-100-2) is blowing cool air, and only occasionally heat was diagnosed as needing a Universal Pilot Module, part #53L9001 also known as 53L90. Question, if we purchase the part how difficult is the installation?
Pilot light stays on but pilot switch keeps resetting
[ 5 Answers ]
I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...
Lennox whisperheat pilot won't stay lit after combustion
[ 1 Answers ]
I have a Lennox whisperheat furnace with electronic ignition.It clicks and lights the pilot for about a second (with a pretty blue flame)then it clicks and the pilot goes out.I know the clicking is a gas valve working,but other than that I don't know.Why won't it stay lit and ignite?Your help would...
Lennox G12 Pilot light problem
[ 2 Answers ]
Hello, I have a Lennox G12 furnace. The pilot light blows out every once in a while.(An intermittent problem) The furnace is located in the hallway in the house. There are no drafts or chances of wind that could possibly blow out this pilot light. It is getting a bit frustrating because it is... View more questions Search
|