Ask Experts Questions for FREE Help !
Ask
    HighwayStar's Avatar
    HighwayStar Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 30, 2008, 07:57 PM
    Gas Furnace Turns On But No Heat/Air Flow
    The furnace ran fine in the morning but some time in the afternoon it stopped. Details: Not sure of brand (didn't see a name when I went into attic). Supposed to be about 10 years old. Does not have a pilot but an "ignition system". When I set the thermostat and turn to "on" position, you can hear the heater start up and you can hear a "click" (igniter?) but you never hear the "whoosh" of the burners and the air never flows. The heater stays on maybe 5 minutes then shuts down. Sorry for the lack of details. Any ideas appreciated. (Gas hasn't been turned off as the water heater and fireplace work fine). Thanks!
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Dec 30, 2008, 08:17 PM

    It`s very important to know the brand and model number. in order for us to tell you what to look for., you need to get up close and personal, to see the igniter to know for sure,, also to see/hear the inducer motor come on and run,, to hear if the gas valve is opening or trying to open,, let us know,, will be glad to try and help,, inside behind the door should be a tag or label with name and model number

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heat turns off [ 1 Answers ]

My whirlpool dryer runs good but the heat does not stay on it comes on then goes off

Hunter 44155C Wiring - A/C turns on during heat cycle or heat will not shut off [ 0 Answers ]

Trying this again with the correct thermostat specs. Sorry, guys! It's a Hunter 44155C and the wires I have going into it are: White - W/B Red - Rh Green - G Yellow - Y1 Jumper from Rh-Rc

Furnace turns off heat and fan continues blowing cold air. [ 14 Answers ]

Carrier split unit Model 58RAV055-GC Circuit Board at Furnace CES0110057-00 Natural Gas I am experiencing a problem with my heat. I have a programmable zones thermostat and noticed that the air was not coming out hot when it was suppouse to be. The temperature was set to 75 but the temperature...

Gas furnace fan turns on but nothing comes out [ 1 Answers ]

When I turn on my gas furnace, the pilot light comes on, but goes off afer a couple of minutes after having produced nothing. When I turn on the manual fan, it starts up, but no air comes out. Any ideas? Thanks


View more questions Search