Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New hot water heater installed, but no hot water pressure. Plenty of cold water?
[ 11 Answers ]
Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....
Hot water heater making thumping noise
[ 1 Answers ]
When I turn on the hot water I hear a thumping or low banging noise which lasts for about a minute and will repeat after a few hours when the hot water is used. This only happens when hot water is first used. I have checked the unit and at this time the unit is not heating water nor has ignition...
Water heater pipe noise
[ 1 Answers ]
My hot water heater pipes make noise
Water heater noise
[ 3 Answers ]
Why would my hot water heater pop and bang when we turn the hot water on, just at first and goes away until you turn it off and back on again. Please note that we have lived here for 3 years and it has just started. Do I have the water temp too high causing it to pop inside.
Water Heater makes noise
[ 1 Answers ]
I have a State Select 50 gal. direct vent, gas water heater, model # PR650NBRT. It was installed when the house was built in 2002. It supplies two bathrooms and is located in the attic directly above both of them. Whenever one of the showers is in use a loud "growling" noise comes from the water... View more questions Search
|