Ask Experts Questions for FREE Help !
Ask
    Black Sheep's Avatar
    Black Sheep Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 26, 2008, 09:27 PM
    Rheem Furnace Cycles Frequently
    The furnace Igniter comes on and the burners light properly but after only a minute or so the burners cut out, then within one minute the furnace relights and again runs for only a short time.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Dec 26, 2008, 10:14 PM

    Clean the flame senser

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace Gives Heat but Cycles Frequently [ 16 Answers ]

OK, Labman and others proved very helpful in the past with my ignitor problem so now I have another question: How long should a proper furnace run between cycles? I have read about the flame sensors and "limit switches" but I'm not sure if this is related to either. My heater seems to go...

Furnace Cycles Too Often [ 2 Answers ]

We recently replaced our old thermostat with a new Noma 5+1+1 thermostat. The furnace used to come on and run for a while, bringing the temperature to 1 degree higher than it was set for. Now it is set for 20.0 C and it comes on at 19.2 and goes off at 19.6. it doesn't even bring the temperature to...

Furnace cycles on and off [ 10 Answers ]

I have a Heil PGAA24C1K1 natural gas furnace with a programmable thermostat, digital type. The unit cycles on and off frequently when heating, I've done a lot of searching but my problem is different that most others I read. First, this only happens when it's cold outside, like 25 degrees or...

Well pump cycles frequently [ 3 Answers ]

Residential well pump cycle on and off frequently

C/A compressor cycles frequently when outside and inside temp are the same, 75 degree [ 3 Answers ]

I have an Amana C/A that runs normally during the day but late in the evening when the outside temp is the same as the inside temp the compressor turns off and then back on again in short cycles. We had a repairman out and he said it was the timer on the unit and that we didn't need it as we had a...


View more questions Search