Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
3 yr old heat pump, heat works, no cool
[ 10 Answers ]
I have a heat pump that was 3 years old in May. We went to change from heating to cooling about a month ago. I noticed later that it wasn't cooling. Checked and found it had tripped the breaker. Reset and instantly threw the breaker again. Called a friend that does A/C work on the side. We...
Heat Pump Doesn't cool, even heats up whenon Cool Setting
[ 4 Answers ]
About a 10 year old "YORK High Performance" heat pump... The heat pump was set to Cool for my summer AC and usually has been working well. At noon on a warm day it stopped The element inside-blower with the freon (sp?) would not get cool and for short times heat up blowing warm air in an...
Heat Pump runs but doesn't heat or cool.
[ 4 Answers ]
I know this is pretty basic--but my older Rheem Classic IX (in FL) seems to be operating fine--except it stopped heating and I think, cooling. It seems to be running fine, without any obvious leaking. It just blows the same cool air on either setting. Where should I start? Are there fuses to look...
Tapping Into Existing ducts for new basement
[ 3 Answers ]
Hello, I am finishing my basement and I need to install about 4 vents for Heating and a/c. The ductwork for the rest of the house is still exposed. I was wondering if there was a special way to tap into the ducts to run these vents throughout my basement (which is only about 600 sqft). If not... View more questions Search
|