Ask Experts Questions for FREE Help !
Ask
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #21

    Dec 19, 2008, 05:29 PM

    So upping the temp didn't work? If your are showering back to back(long fifteen, or twenty minute showers), then thirty gal won't do the job. Sorry but if the replacement of the thermostats doesn't work, then check dip tube(not likely), you will most likely have to upsize the water heater. Go to a good plumbing outfit, and give them the measurements of the space you have, let them know that you would like a forty or fifty gallon water heater that will fit in this space. They should be able to find you something To fit your needs. Take care.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #22

    Dec 19, 2008, 05:31 PM
    They may try to sell you a tankless water heater, please avoid these if at all possible. Too much maintanance required and they are ungodly expensive. Seen quite a few of them and haven't heard many good words about them.
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #23

    Dec 19, 2008, 07:16 PM
    Quote Originally Posted by mygirlsdad77 View Post
    They may try to sell you a tankless water heater, please avoid these if at all possible. To much maintanance required and they are ungodly expensive. Seen quite a few of them and havent heard many good words about them.
    MyGirlsDad77: I cannot disagree with you more. As somebody, who has two of the tankless heaters installed in my private residence since 2002 - and who installs about 50 tankless water heaters as a factory authorized installer a year - I have to conclude that your statement is false and misleading.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #24

    Dec 20, 2008, 02:50 PM

    You are correct Milo. I guess I should have mentioned water quality is key. Im sure they work great in a lot of situations. Just need to be properly installed and maintianed. I let a few bad comments about them alter my thinking about them. Sorry again. I misspoke.
    Thank you for clearing it up.
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
     
    #25

    Dec 20, 2008, 05:33 PM

    One thing that you have to remember is that if your elements amped out at 12 amps that means that you only have 2880 watts on each element and only one element works at a time, so the recovery is not going to be great.

    I am glad that you got it to a point you can get two baths.
    Pivoman's Avatar
    Pivoman Posts: 17, Reputation: 0
    New Member
     
    #26

    Dec 21, 2008, 03:01 PM

    Well this may sound silly. Did you increase the T/Stat temps to give you hotter water? One is located on the Bottom naturally and one near the Top. Perhaps they need replacing. I just recently replaced my T/stats on my Hot water heater, which is also electric. And it's 17 years old. And works great... As for your faucet, I highly doubt that's your culprit. Unless your mixing valve is not working correctly. Good Luck...
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #27

    Dec 22, 2008, 05:59 PM

    Read all post before answering please. All of this was covered previously. But good answer none the less.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New hot water heater installed, but no hot water pressure. Plenty of cold water? [ 11 Answers ]

Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....

Need help deciding between a tank or tankless water heater [ 19 Answers ]

Which one saves me money; the tankless water heater or conventional tank water heater? :confused:

Surging water pressure & leaking water heater relief valve [ 19 Answers ]

Just recently the pressure of our water in the house surges when we turn a faucet on, and the city water company verified that our pressure in the house when we open a faucet is higher than the pressure in the lines in the street, and after the water runs is at a normal pressure (meaning their...

Water heater hookup with sidearm supplimental heater [ 0 Answers ]

Hello: I'm hooking up a sidearm heater to an existing electric water heater for use with an outdoor wood furnace. I've seen diagrams showing the upper port of the potable water side hooked up to the anode port, the TPV port, and the cold water inlet port. My initial thought is that plumbing it into...

Connecting a tankless water heater and separate hot water heater [ 6 Answers ]

What I have is this. An oil fired boiler that generates hot water for my house baseboard heating system. Contained within the boiler is a tankless heater that is heated by way of the firebox in the boiler. The tankless heater is used only for domestic hot water. It has a separate CW supply to the...


View more questions Search