Ask Experts Questions for FREE Help !
Ask
    neeneesdad's Avatar
    neeneesdad Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 19, 2008, 05:22 PM
    Goodman furnace
    Just bought it and installed furnace yesterday
    It lites and runs about 1 min,than the flame goes out and the plenum only gets luke warm. It blows cool air
    Thanks.
    twinkiedooter's Avatar
    twinkiedooter Posts: 12,172, Reputation: 1054
    Uber Member
    		  
    #2

    Dec 19, 2008, 05:45 PM

    Did you install it? If is brand new you could call the manufacturer and have them send out someone to troubleshoot/fix it if we can't figure out your problem.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #3

    Dec 19, 2008, 07:40 PM

    Who is the contracter that installed it? Call him back out to finish his job. I hope someone that is not a certified goodman tech installed it,, you may not have a warranty if that's the case.
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #4

    Dec 19, 2008, 09:52 PM

    wmproop is exactly right. If you installed this unit yourself then you are SOL on the warranty. Call in an EXPERIENCED, QUALIFIED service company.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Goodman Furnace [ 2 Answers ]

My furnace worked fine last season, Air Conditioning worked great over the summer. This year I turned the switch to heat and the blower ran for about two minutes but then shut down? I went and looked at the furnace and I shut it off and turned it on again. The blower starts but the igniter does lit...

Goodman Furnace [ 2 Answers ]

What does A three blink code on a Goodman 80 plus gas furnace mean

Goodman gas furnace [ 3 Answers ]

I have a goodman gas furnace, gms91155dxa for about a year. Recently I notice the furnace repeats on and off while it didn't reach at set temperature. After the heater is on, it runs some minutes and it shuts off itself. And the draft inducing motor runs, the ignitor is on and gas blows and in...

View more questions Search