Ask Experts Questions for FREE Help !
Ask
    cwharper2k's Avatar
    cwharper2k Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 19, 2008, 06:55 AM
    Hot Tub GFI wiring
    WhT is trick with the ground and white wires? Is there a rule or a drawing that you could share about how to isolate the grounds? CWH
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Dec 19, 2008, 08:14 AM

    No real trick, The Ground connects to all exposed metal parts, junctions, boxes, and doesn't carry loads. The Neutral does, You also need GFI protection. Should understand completely or shock and/or death could occur.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Dec 19, 2008, 08:15 AM

    This page may help:
    Wiring a Hot Tub - Electrical Installation and Wiring Diagrams
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
    		  
    #4

    Dec 19, 2008, 08:21 AM

    The G.F.I has to be rated to the amps you are going to carry on that circuit and once you go through that G.F.I. The other outlets will be G.F.I. protected when wired correctly and grounded correctly
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring direction for a multi wiring system thermostat! [ 3 Answers ]

I have a 2 wire system (3 phase), need to connect multi wiring system thermostat! Need to know if, its correct to just use line#1, and the device already has a jumper?

Janitrol wiring to rth3100c wiring [ 1 Answers ]

I've taken off the cover and the wires are all OK but the black one where does it go to? My heater won't come on (well some times the AC come on with out me turning it on.)

Honeywell wiring different from old thermostat wiring [ 2 Answers ]

I purchased a non-programmable digital thermostat to replace an analog thermostat with wiring red, white yellow and black. How do I match the wiring? HELP!!

John Deere - My dog ripped the wiring Out - Need Wiring Diagram or photos [ 2 Answers ]

I have a 3 year old L110 that ran fine until last week. I think my dog chased a chipmunk up under the hood and in trying to get to him ripped a bunch of wires out. I have spliced back together the obvious wires (color coded) but I have one black wire that I assume is a ground(?) and the two...

View more questions Search