Ask Experts Questions for FREE Help !
Ask
    spfdcar50's Avatar
    spfdcar50 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 18, 2008, 12:15 AM
    Tire Specs.
    I own a 1994 Dodge Caravan with tires size 195/70/R14 on it. I wanted to know if I would be able to put 195/60/R14 on the van without having any issues with incorrect tires?

    I want to put the 195/60/R14 tires on the front and leave the 195/70/R14 on the rear.
    twinkiedooter's Avatar
    twinkiedooter Posts: 12,172, Reputation: 1054
    Uber Member
     
    #2

    Dec 18, 2008, 05:48 AM

    Not a good idea to have different sized tires on a vehicle. I once had a Dodge B200 van that I put larger tires on the rear - just like you want to do. Oh, it looked good and all, but I did notice that my highway speed was off and that stopping with the larger tires on the rear caused problems. It's up to you what you do, but I've already been there and done that and now know better not to do this type of thing again to my vehicle due to the safety factor.
    450donn's Avatar
    450donn Posts: 1,821, Reputation: 239
    Ultra Member
     
    #3

    Dec 18, 2008, 07:44 AM

    To answer your question any good tire shop will have a chart that lists the alternative tire sizes for any vehicle that drives up. Ask them.
    this8384's Avatar
    this8384 Posts: 4,564, Reputation: 485
    Ultra Member
     
    #4

    Dec 18, 2008, 08:31 AM

    Having smaller tires on the front isn't going to hurt anything, as long as you keep the same size tire on both sides of one axle.
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
     
    #5

    Dec 18, 2008, 05:00 PM

    Not a good idea <quote> Agreed! Most, if not all tire shops nowadays will NOT mount a different size tire other than what's labeled on the drivers door.
    Think safety first!
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
     
    #6

    Dec 21, 2008, 06:35 AM

    It is never a good idea to put two or more different size tires on the same vehicle, especially if the vehicle is equipped with Anitlock Braking System (ABS) because the "rolling" size will confuse the ABS control module with a slip/spin.
    It's also not a good idea to move to a smaller tire because the smaller tire doesn't have the same carrying capacity plus your actual gas mileage will be affected.
    RickMN's Avatar
    RickMN Posts: 244, Reputation: 52
    Full Member
     
    #7

    Dec 21, 2008, 01:19 PM
    Everyone that says it's a bad idea is RIGHT! In addition to what they've told you, consider the effect of putting the smaller diameter tires on the front. You've now changed the ride height of the vehicle and that changes all your suspension angles. The front end will ride lower to the ground. If you're set on doing this, you'd be better off keeping the original sized tires on the front--of course, smaller tires on the rear will also screw up your alignment.

    Here's an article on tire placement: Replacing Two out of Four Tires

    You should always have the tires with the most tread on the REAR wheels in a front wheel drive vehicle. The extra tread prevents spin out in turns.
    lilsnell8's Avatar
    lilsnell8 Posts: 55, Reputation: 1
    Junior Member
     
    #8

    Dec 28, 2008, 01:53 PM

    You are not going to have a problem as far as driving but it affects your fuel milage and control the tirs on the frot will sit a tad bit shorter than the back but you'll be o k as far as getting back and forth just don do any real traveling the vechicle is designed for a certain tire size

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kz650 specs [ 3 Answers ]

Can anyone tell me what the carb float measurement should be for a 1978 kz650. I just rebuilt the carbs and they still leak gas from the bowls. Any suggestions?

Wiring specs [ 2 Answers ]

I am trying to run an electrical wire to power a 5 ton central air - 220/40 volts - 40 amps. Its length is approxaimately 60 feet from the panel - what type /wire gauge do I need?

Belt specs [ 1 Answers ]

I need to find the dimensions for the belt on a 1999 yardman tractor the oem part number is 742-0485 according to the parts manual. The tractor is second hand and I believe the belt on it is incorrect and it keeps throwing the belt and cutting it .Thanks

Engine oil specs [ 1 Answers ]

What will happen if you put 3 quarts of oil in a 1&3/4 capacity engine? I am having a trouble with the engine cranking with the spark plugs installed. When you take the spark plugs out, oil pumps out when cranking engine.


View more questions Search