Ask Experts Questions for FREE Help !
Ask
    serplus's Avatar
    serplus Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 16, 2008, 11:54 AM
    Wiring a 2HP GE electric treadmill motor
    I have a GE 2HP 120V electric treadmill motor and it didn't come with any wiring diagram. I want to use it on a variable speed belt drive unit. The motor is a type BD6219 and it has seven wires, one of which is a ground attached to the chassis frame. The other six are all various colors and disappear into the motor. Can someone help me with a diagram or point me to a site that would have it?
    thanks
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Dec 16, 2008, 12:18 PM

    It's a 3 phase motor and needs a controller to convert from single phase to 3 phase. Probably a standard variable speed drive controller would work.

    An ohm meter would help you find the phases but not the direction of the magnetic field.

    A model # might be useful too.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Electric motor wiring [ 4 Answers ]

I have a hayward motor c48k2n143b1 and I cut the wires from the breaker switch to put a intamatic timer in the system. Somehow I rewired it wrong it keeps burning out the clock timer. It will run manually. But something is wrong. It has a green (ground?)and two red. So I have two red wires that...

Treadmill impact reduction and calorie counter on treadmill [ 2 Answers ]

I was wondering what the best % to set your treadmill on concerning impact reduction. I was also wanting to know a question about the calorie counter on treadmill. I was told that the number of calorie that are shown that you burn during a workout on a treadmill were not accurate number of...

Electric motor wiring [ 4 Answers ]

This is a 480v 240v motor it is wired 480v there are 9 termial points there are 3 jumpers they run from top to middle my t leds are on botton where do I move the jumpers to make it 240v

Repair of DC motor powered treadmill [ 1 Answers ]

My treadmill has lost its power/torque. It still operates normally except that when you step on it the motor can't pull the load. I'm wondering if it is a problem with the motor or a problem with the electronics supplying the power to the motor.

Wiring a GE electric motor [ 5 Answers ]

HI, I have a GE motor on my table saw that was wired for 220vac. I want to change it back to 110vac. Problem is that the wiring plate is missing. Motor number is 5KC49TG1458X IT'S A 2HP motor Currently it has the following wires connected motor has 4 threaded studs marked 1-2-3-4- Power...

View more questions Search