Ask Experts Questions for FREE Help !
Ask
    HoleInOneHusker's Avatar
    HoleInOneHusker Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Dec 15, 2008, 07:34 AM
    Flame sensor location to clean
    I am trying to find the flame sensor on my York furnace to clean it. We had to do this last year also. I can not remember where it is!!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 15, 2008, 07:40 AM
    Quote Originally Posted by HoleInOneHusker View Post
    I am trying to find the flame sensor on my York furnace to clean it. We had to do this last year also. I can not remember where it is!!!

    This link was available on search

    https://www.askmehelpdesk.com/heatin...at-292013.html
    HoleInOneHusker's Avatar
    HoleInOneHusker Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Dec 15, 2008, 01:36 PM

    Thanks... I am an extreme novice... I do not know where the flame sensor is.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Dec 15, 2008, 02:01 PM
    Inside near the gas train at the burners. There is a picture on the link as to what it might look like and where it is located.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Clean tempstar flame sensor [ 1 Answers ]

I have a Tempstar model # nugk100dh08 furnace. I am trying to clean off the end of the flame sensor. Do I need to take the ignitor/sensor unit off? If so, I see that it has 2 screws on top of the unit. Do I just remove those and it drops down so I can clean? The problem I was having was the flame...

Flame Sensor [ 2 Answers ]

I have a RHEEM furnace with a hot surface ignitor. The flame sensor will only register .01 microamps, not enough to keep the burners fired. What is the procedure for checking polarity for the furnace, and what could other possible causes be? The flame sensor is new, and the gas pressure is 3.5...

Bad Flame Sensor? [ 1 Answers ]

Thermostat calls for heat Blower comes on for 30 seconds Ignitor glows Gas kicks on & gas ignites in first burner Travels down the to the other three burners including the last one where the flame sensor resides Furnace stays lit for a few seconds and then goes out with a lockout code The...

Flame sensor [ 1 Answers ]

I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.

Flame Sensor [ 5 Answers ]

How can I replace a flame sensor in a Trane heating unit?

View more questions Search