Ask Experts Questions for FREE Help !
Ask
    jack6863's Avatar
    jack6863 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 7, 2008, 05:01 PM
    Which aquastat to use
    Hello looking for some help on the correct way to wire my aquastat ihave a dunkirk xe-5 gas boiler a taco sr504 a boilermate indirect wh.which I will run as a priority I have a honeywell 8148 and a 8124 which one would work the best I plan on running cold start on the boiler how would I wire it so primary pump runs with each zone pump kicks on I have radiant tubing 4 zone pumps and priority on supply side of boiler what is most efficient way to run boiler looking for an expert opinion thanks for your time
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 7, 2008, 05:57 PM
    I show no XE-5 boiler listed on there site.

    Products For Sale at Dunkirk

    I can tell you this much if that baby is cast iron you have to keep the temps up or it will damage the boiler. Cold start?? Might not be a good idea depending upon what you are really going to do. BTW I suggest you get a 5 zone control panel for complete control.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Aquastat L8148e. [ 2 Answers ]

I have a dunkirk boiler pwb-5d , and an aquastat L8148e. The flame rollout sensor grounded out against burner. From a melted wire. In turn caused the switching relay to click on and off rapidly.I fixed the wire on the rollout sensor. Tried to turn on boiler and nothing happened. So I thought the...

Aquastat L8148e dunkirk boiler [ 1 Answers ]

Dunkirk boiler pwb-5d , and an aquastat l8148e. Replyed After checking to be sure no other control is wired into the aquastat and has failed replace the aquastat contro always double check all circuits Don't know how to reply to the answer so I am doing it like this , So can I safely run the...

Common wire for thermostat and aquastat relay [ 10 Answers ]

I just purchased a totaltouch P286-1300 which I know is a little bit of over kill for my system, but I like the way it looks. Anyway, I just a simple two wire baseboard gas heating system. When I connect the wires the screen lights up and comes on just fine. When I use the system the thermostat...

View more questions Search