Ask Experts Questions for FREE Help !
Ask
    kevinstoy's Avatar
    kevinstoy Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 24, 2008, 03:17 PM
    Weilmclean 155 zone valve wiring
    I just purchased a ultra 3 155 BTU boiler and need to wire two zones valves and a indirect hot water heater to it. The manuel only tells how to wire to circulator pumps and not zone valves. I used honeywell V8043e zone valves and I'm not sure how to wire them into the boiler.

    Thanks
    Kevin @ [email protected]
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 24, 2008, 07:03 PM
    This is a set of instructions from Honeywell. It has examples of wiring. All the info you need is contained in the link below. If the information contained in the link does not satisfy your requirements you will need to call for ON Site Service to figure out your wiring because it is nonstandard and will need greater care to make sure no damage happens.

    http://customer.honeywell.com/techli.../95C-10932.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Zone valve problem [ 5 Answers ]

Zone valve for upstairs will not open. Already replaced thermostat. The only time I have heat upstairs is when the valve in manually opened and the downstairs heat kicks on. Any help or advice would be great! Thank you.

Zone valve [ 1 Answers ]

Got a white rogers zone valve spinning and not stopping ,has my end switch burned out .

Valve does not turn on furnace in one zone [ 4 Answers ]

I am having problems with one zone of a two-zone heating system. The thermostat does not function; previously this happened intermittently, and turning on the valve manually while the thermostat was set high enough started the furnace. Now, turning on the valve does not help either; the only way to...

View more questions Search