Ask Experts Questions for FREE Help !
Ask
    geobair's Avatar
    geobair Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 11, 2008, 04:55 PM
    Removing Clutch Cable - Craftsman LT 1000
    I have a Craftsman Lawn Tractor LT 1000 which I'm attempting to replace the clutch cable. The end of the cable near the clutch level has a plastic piece which slides into a metal bracket. I can not figure out how to get the old one out of the bracket so that I can replace it with the new one. I'm sure there is a method which I'm just not familiar with. Can you help me?
    jsfocke's Avatar
    jsfocke Posts: 310, Reputation: 37
    Full Member
    		  
    #2

    Nov 12, 2008, 10:59 AM
    I think you might be talking about the deck engaging lever in the dash. Is that right?
    geobair's Avatar
    geobair Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 13, 2008, 09:49 AM
    The part listing said clutch cable... but you are right I believe it is referred to as deck. It is the large handled lever which engages the mower blades.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman LT 1000 42 inch deck [ 16 Answers ]

I replaced the drive belt and a pulley that were broken. Now it will not move. It is an automatic. What actually makes the tractor move. The belt turns but doesn't go anywhere. Thanks

Craftsman ltx 1000 lawn tractor won't run [ 2 Answers ]

HI, My craftsman LTX1000 lawn tractor with a B&S 21.5 HP engine will not stay running. I have changed the fuel pump fuel lines and fuel filter and get the same result. It will start and it acts like it is running out of gas. If I pull the choke it will run a little longer then die. I have...

Springs under a Craftsman LT 1000 rider [ 7 Answers ]

Hi, I was mowing the other day and my mower ran out of gas. Well I put more gas in and started to mow again and it started but every time I let off the clutch it starts to die. I got looking underneath and I see a long spring that's connected on one end but not the other. Could that be the problem...

Craftsman T L 1000 RIDER [ 1 Answers ]

When I Start The Rider Up It Starts Fine. When I Release The Clucth, In Gear Our In Neutral, It Dies Out. If I Have It Running W/ The Clutch In And Engage The Blades, It Dies Out. Any Ideas?

LT 1000 Craftsman rear axle slipping out [ 1 Answers ]

I have a Craftsman LT 1000 16.5hp the right rear axle keeps slipping out of the housing and then it will disengage and quit moving. I was wondering if anyone could point me in the right direction to fixing this or maybe even how to get a service manual I do not know how old it is I got it second...

View more questions Search