Ask Experts Questions for FREE Help !
Ask
    bvsharris1's Avatar
    bvsharris1 Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 6, 2008, 05:07 PM
    Trane xv80 not staying lit
    My furnace is 5 years. Every time it calls for heat it fires up just fine but then after 3 sec. the gas turns off, it repeats this cycle until it locks out the system. I have reset the system, checked all the wiring for loose connections but cannot get it to run. Please help me.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Nov 6, 2008, 05:28 PM

    Not real familiar with trane units, but I'm betting there is a flame senser. Locate the flame senser, clean it and see if your worries go away.


    Little more info... The flame senser will be located directly in front of the burner, on one side or the other. Remove, clean with sandcloth, steelwool, sandpaper, or any abrassive cloth. Reinstall. And let me know if it works. Like I said, I'm not familiar with train, but you are looking for a single probe
    bvsharris1's Avatar
    bvsharris1 Posts: 2, Reputation: 1
    New Member
     
    #3

    Nov 6, 2008, 05:49 PM

    I greatly appreciate the help. Thank you.
    hcjohn's Avatar
    hcjohn Posts: 1, Reputation: 1
    New Member
     
    #4

    Feb 11, 2012, 08:34 AM
    Perfect answer. Pulled out the sensor and though it did not look that bad, the resistance across was pretty high. Cleaned as you suggested and system fired up with no problems. Thank you!
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #5

    Feb 11, 2012, 01:35 PM
    Glad it worked for you too.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

TRANE vs Amana in New Home: Is a TRANE upgrade worth $4k? [ 8 Answers ]

Background/Details: Building new home in North Texas. Closing at end of August. Builder and I are in dispute over what hardware to install for the AC. House is gas heated so this is about the AC side only. The AC hardware that comes with the house is made by Amana (under license to Goodman...

HVAC Trane xv80 blower motor [ 2 Answers ]

Trane XV80 Installed 2002 My blower does not come on; I turned t-stat to fan only; fan motor felt cold to touch and turns freely when spyn: defeateded the safety switch on front; checked voltage at the leads from the circuit board to fan motor for the white and black leads(124 v); Should I...

Trane XV80 blower not running [ 2 Answers ]

:( I have a Trane XV80 blower motor will not run, it will spin freely, the control board has normal slow blink, but GS3 yellow LED light above green wire is on, when A/C turned on the condensing unit runs but no blower, Heat on no blower but get trouble light high limit lockout, and just turn...

Quote on 2 1/2 ton Trane XR13 and var spd Trane Blower [ 2 Answers ]

I was just quoted on a 2nd floor A/C replacement, condenser and var speed blower, 2 1/2 ton Trane XR13 with upgrade options. Live in CT Are these prices sane ? Includes removal of old unit, upgrade of refrig line, added insulation on old ductwork - work to be done in walkup attic Quote...

Trane xv80 [ 1 Answers ]

Main blower mysteriously stopped working on Trand XV80. I've gone through the owner's manual. No fix. Vent blower works, flames present, no main blower. 16 Months old. Any suggestions?


View more questions Search