Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
R410 mini split has cold liquid line
[ 10 Answers ]
I have a R410 mini split. Flare fitting leaked so I pulled all the gas out and fixed the leak , Put it in a vacuum and weighed in the charge. Unit came on and cooled but liquid line was very cold. Suction pressure was about 120 and 37 degrees. Well I went away for awhile and came back later. Both...
R410 mini split has cold liquid line
[ 1 Answers ]
Reply to aldermat. I did not take temperature of the liquid line but I can tell you when I felt it, it was cold or colder than the suction. But the suction pressure was close to being right on at 115# and 37 degrees. And the unit did blow cold air but only when the compresser ran.
Mini-Split wiring
[ 12 Answers ]
I am installing a Mitsubishi mini-split with an indoor and an outdoor unit (MUZ-A15NA). I ran 220V wire from the electrical box outside. It is on a 15 amp breaker as the instructions have it rated as 15 amp max. I purchased a disconnect switch for the outdoor unit that is a 60 amp fuseable...
"Popping noise" coming from mini-split AC unit
[ 1 Answers ]
We have an "AllStyle" brand mini-split AC in our bedroom. It's about 1.5 years old. It works fine, except about a month ago, it started "popping" and "cracking"--making it virtually impossible to get a good night's sleep! The sound is like that of plastic-on-plastic expanding or contracting...
Mini split Problems! Turns off
[ 4 Answers ]
Hi, I have a couple of mini split ac's and am having some issues. One works fine for about 10-30 minutes and then just turns off. Fan stops but it puts out cold air when it runs. This one is a bondaire r22 unit. I have another 33,500 BTU dual zone mitsu mr slim 17+17. This unit doesn't cool... View more questions Search
|