Ask Experts Questions for FREE Help !
Ask
    brittykitty's Avatar
    brittykitty Posts: 76, Reputation: 2
    Junior Member
     
    #1

    Oct 20, 2008, 01:23 PM
    Light source
    7. The tip of the stem of an oat leaf plant is covered with aluminium foil. A light source from one side will

    A. cause the stem to bend toward the light source
    B. cause the stem to bend away from the light source
    C. cause the stem to wither an die
    D. have no effect on the stem


    I say that it's a but the aluminium foil might make it have no effect since light would be coming from both sides? Not to sure.. any thoughts?
    Unknown008's Avatar
    Unknown008 Posts: 8,076, Reputation: 723
    Uber Member
     
    #2

    Oct 21, 2008, 04:35 AM

    If it's like that:

    {| |}
    {| |}
    {| |}
    {| |}
    {| |}
    {| |}

    Where the '{ }' are the aluminium foil, and the '| |' represent the stem, I would say that the aluminium foil will prevent light from reaching the stem, so D. It's only a suggestion, OK?
    brittykitty's Avatar
    brittykitty Posts: 76, Reputation: 2
    Junior Member
     
    #3

    Oct 26, 2008, 04:32 PM

    OK thanks :)
    Credendovidis's Avatar
    Credendovidis Posts: 1,593, Reputation: 66
    -
     
    #4

    Oct 26, 2008, 05:39 PM
    Hello brittykitty

    The ability of a plant to bend toward a light source is known as phototropism. The hormone in a plant stem auxin causes elongation. Light destroys auxin when it strikes the stem. Because auxin is still present on the shaded side of the stem, the cells on the darker side are able to elongate more than the cells on the lighted side, causing the plant to bend toward the light. Phototropism by sunlight is also called heliotropism.

    The by foil covered tip of the stem receives no sunlight, so no bending will occure there.
    The correct answer is D.

    :)

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search


Check out some similar questions!

Source for Hampton Bay Ceiling Fan CFL Light Bulbs [ 1 Answers ]

I have a 3X3 year old Hampton Bay Ceilings with PLSS13W2700 sprial 4 pin connectors. I can't find replacements that fit into the housing that are 4 pin. Anybody know of a source?

Ratings source? [ 1 Answers ]

:o :o Who decides the 4-star etc movie ratings? Are they polled? Is there some super movie board? It can't be on attendance, can it! Also--how come it says Times Roman here, and color, but that's not what appears? :o :o Thanks ScottGem--are these newspaper, magazine, radio and TV...

Splicing for source [ 4 Answers ]

I'm planning to add a new switch for recess lighting. I've located the hot source for the switch not too far on the same wall where the switch will be. If I cut up the wall where the source is and then just do a 3 ways splice using wire nuts and then close the wall, is this sufficient? I know...

Wiring 120V light from 240V source [ 6 Answers ]

I currently have a well house that has a 240V source on 12-2 wire powering a submersible well pump. I would like to wire in a 120V light. Can this be done using the 12-2 wire already in place or do I need to remove the 12-2 wire and install 12-3 wire? (It is approximately 60ft from the main house...

Open Source [ 1 Answers ]

Microsoft said on Wednesday that the U.S. software giant would offer licenses for some of its source code in a bid to comply with antitrust requirements set by the European Commission.Yipee. This of course does not mean,it's time to open the champagne bottles,phone a "rival",and say how much is...


View more questions Search