Ask Experts Questions for FREE Help !
Ask
    sadutche's Avatar
    sadutche Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 18, 2008, 10:36 AM
    Lighting the pilot light on a payne 125u-19a
    I need to light the pilot on a payne model 125u-19a. I can find the pilot/on, but cannot figure out where the pilot nipple is inside the furnace. Can you direct me?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Oct 18, 2008, 04:38 PM

    If you know this little about a gas furnace,it would be much safer for you to have someone that knows how to come and show you as they light it for you,, watch very,very carefully
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Oct 18, 2008, 05:09 PM

    Good answer. Some pilots are located in very hard to get to places. There is most likely a cover you can remove to make the job easier.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Lighting the pilot light of a State gas hot water heater? [ 6 Answers ]

I cannot get the pilot light to stay lit on a 50 gal "State" gas hot water heater, Model PRX50NBRT. I have followed the instructions on the front of the tank. I just had a black out and the light goes out without power. This has happened before, and has been tricky in the past. I forgot...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

Lighting the pilot [ 1 Answers ]

I can't light my pilot. Because there's no pilot button to push, it has a control knob; that only goes to on or off. The knob doesn't depress down or up. It has a pilot adjust screw and that's it. How do I light it?

View more questions Search