Ask Experts Questions for FREE Help !
Ask
    guardian77's Avatar
    guardian77 Posts: 16, Reputation: 1
    New Member
    		  
    #1

    Sep 26, 2008, 01:35 PM
    B&S pulley removing
    Have a b&s 12 hp old model need to place engine. Have to use the pulleies on the new one to make it work. Any ideas on how to remove them off the shaft and on the newer one.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Sep 26, 2008, 01:38 PM

    The pulleys are on a tapered shaft with a pin, so they have to come straight up.

    Sometimes a little GENTLE hitting with a hammer or you have to resort to a pulley removal tool.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Box, Bag, and a Pulley [ 1 Answers ]

A box of mass 1kg and a bag of mass 2kg are suspended from a rope passing over a pulley of moment of inertia 0.02kg*m^2 and radius 10cm. The rope does not slip with respect to the pulley. The bag is released from rest at a height of 2cm above the floor. Find the speed of the bag whe it hits the...

Pulley 14.5 hp murray [ 1 Answers ]

I need to remove a belt pulley on my riding mower. I got the big nut off, but I don't know if the pulley is threaded on the shaft or pressed or just goes on the shaft. I've tapped it with a hammer, but I can't get it to budge. Thanks for any help.

'88 GMC AC pulley removal [ 6 Answers ]

My buddy has a 88 GMC pick-up truck and his AC pulley seized up. Any help on pulling this out?

B&s 14.5 HP - Drive Pulley [ 1 Answers ]

The keyway is gone, when I try to loosen the bolt, the engine turns. How do you remove the bolt in question when you do not have impact tools available?

Removing MTD engine pulley [ 3 Answers ]

I need to replace my drive belt but cannot get the pulley off, motor spins? Any suggestions? Also it is reverse thread correct? Thank You

View more questions Search