Not your question?
Ask your question
View similar questions
Check out some similar questions!
Dog collar sizes
[ 4 Answers ]
We all know that a dog's collar should fit snuggly, but with enough room to allow two fingers to slip underneath it. But where on the dog's neck do you measure that? Trink's got a roughly triangular neck. If the collar is tight up by the ears, she will choke if it slides down her neck. And if...
Tip sizes
[ 1 Answers ]
Which tip size should you use for sanding sealer?
Name of lumber sizes
[ 4 Answers ]
What would a piece of lumber the following sizes normally be referred to in the industry? a. 1-1/2" x 3-1/2" x 92.5" fir b. 1" x 5-1/2" cedar
Drain pipe sizes and venting sizes
[ 4 Answers ]
1.) What dia. Drain pipe is used for the shower/tub? 2" ? Is that ID or OD? 2.) What dia vent pipe is for the shower/tub? 2"? 3.) I'm going to put a vent in for the shower/tub in my basement. It starts at the slab then goes straight up about 7ft. And then does a 90 and then is running...
Duct Sizes?
[ 1 Answers ]
HELLO, I HAVE RECENTLY ADDED AN ADDITION TO MY HOME. I NEED TO HOOK MY ADDITION INTO MY CENTRAL HEAT AND AIR. I DO NOT HAVE ANY IDEA OF WHAT SIZE DUCT TO RUN AND WHEN TO REDUCE DOWN. ANY SUGGESTIONS? THE TOTAL LENGTH FROM MY DELIVERY TRUNK IS PRETTY CLOSE TO 50' LONG. MY ORIGINAL DELIVERY TRUNK IS... View more questions Search
|