Ask Experts Questions for FREE Help !
Ask
    jimsac1's Avatar
    jimsac1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 21, 2008, 07:37 AM
    OLD furnace
    I am trying desperately to 'date' the furnace in our home. The home was built in the very early 1900's and has remnants of a coal chute, etc. The furnace in place now is an aqua colored Rheem and is outfitted with a Crown A-40 humidifier (disconnected) and a sticker on the backside stating it is capable of AC also. The Rheem # is 2432-130 , series #AF-AFO. It states it is 154,000 BTU built in New Castle, Delaware. I would love to figure out the age of this furnace for curiosities sake but also to update my home's system if need be. Anybody? Please? Thanks!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 21, 2008, 07:01 PM
    Contact Rheem manufacturing co.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #3

    Sep 23, 2008, 07:43 PM

    Is it OK with the wife for you to date a furnace,, sounds like trouble brewing
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a furnace thermostat to manually operate the furnace fan [ 2 Answers ]

I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Furnace not heating the house. Damper on the furnace not opening. Motor then shuts. [ 4 Answers ]

My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad:

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

View more questions Search