Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
230 volt welder with 2 wires outlet with 3 wires.
[ 7 Answers ]
Hello. I have an older stick welder that has a ground, white wire and black wire. The outlet I have to connect to has a ground, black, white and red wire. Is there a way I can connect the old welder to the newer wires? I know the red and black are hot but what about the common white wire? What...
Short Between Ground and Live Wires
[ 3 Answers ]
During the building inspection of my home that I purchased one outlet tested hot reverse, the building inspector said I simply needed to switch the wiring. i.e. Black to Brass and White to Silver. He also advised me to put in a GCFI outlet since it was in a bathroom. I proceeded to do this...
Outdoor electrical outlet keeps tripping gfci outlet
[ 3 Answers ]
Until just recently my christmas decorations would light up when we plugged them into the outdoor electrical outlet. Now when we plug it in the gfci outlet in the garage keeps getting tripped and the lights won't come on. Even when we reset the gfci, once we plug in the chord it gets tripped...
GFI-6 wires to one outlet
[ 1 Answers ]
My question is that I have an outlet in the bathroom right next to the sink. (Big NO NO) This outlet has 3 whites to it and 3 blacks to it with the proper grounds. This would place it in the middle of a series. How do I distinguish the line and the loads to replace the outlet with a GFI Outlet??...
Thermostat wires too short
[ 1 Answers ]
I am removing a White-Rodgers thermostat in my apartment. When installing my Honeywell RTH7000 I found the wires are all too short by about 1/4 inch. Pulling on the wires does not help. Suggestions? View more questions Search
|