Ask Experts Questions for FREE Help !
Ask
    singh08's Avatar
    singh08 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 13, 2008, 02:20 PM
    Bath tap not working
    My bath tap which has the hot water is not working , initially the flow got gradually decreased until one day it totally stopped . All the other taps with the hot water are functioning normally
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Sep 13, 2008, 03:47 PM
    Two handle faucet or one. If its one you have a cartrridge mostly and the inlet port is plugged with debris. Power flush your water heater more often to avoid this. Do you know how to remove the cartridge and clean? If not try to give us a brand/model or picture.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bath/Shower Diverter Not Working Properly [ 10 Answers ]

I am trying to replace the diverter in my bath/shower. I have bought a Waltek replacement part (W-7) (Master Plumber replacement) It apears to be the same type of diverter as the diverter I am trying to replace but I cannot be sure until I have removed the old one. My challenge is trying to...

I want to convert a half bath into full bath [ 3 Answers ]

Hi, I hope somebody can help! My Mom-in-law is visiting and she has difficulty climbing the stairs. Hence I wanted to convert the half bath at the lower level into a full bath.Any stop gap measure would also work.I really want a low cost solution as we are planning to sell our house in the next...

Adding master bath to 1 bath home [ 2 Answers ]

I am looking to add a master suite and bathroom to a 2 bed 1 bath slab home. The existing bath is behind a wall adjacent to the space where I will add the bath. My main concern is how I tie into the drain lines. I assume I will have to chip the slab or is there a way to elevate the toilets and tie...

Adding bath drain in concrete for existing half bath [ 1 Answers ]

I want to turn a half bath into a full bath in my basement. Currently the washer and dryer along with the water heater are in the half bath along with the commode and sink. I want to add a bath tub and the lay out of the room is such that the tub installation would probably require less work if it...

Cutting cement for plumbing 3/4 bath to full bath [ 3 Answers ]

We are currently in the middle of changing our basement 3/4 bath into a full bath. The bathroom is 5.5' by 13.5'. We want to put the sink where the shower was and put a tub/shower where the sink was. (because the space where the shower was is too small for a tub). The old sink drain is centered 4...

View more questions Search