Ask Experts Questions for FREE Help !
Ask
    fvajhk's Avatar
    fvajhk Posts: 3, Reputation: 1
    New Member
     
    #1

    Aug 17, 2008, 01:23 PM
    Outsdie GFI
    My outside outlets were left open during a storm and now it does not work. The breaker marked "outside GFI" was tripped. I had reset the breaker and went back to check but it still does not work. I also found out that my garage outlets and my other outsdie outlets are not working either. I've tried resetting all of the GFCI in the entire house.

    What is "outside GIF"? And how do I fix this problem?

    Thanks and looking forward to hearing from the experts.

    Jenny K
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
     
    #2

    Aug 17, 2008, 01:29 PM
    Does the breaker have a little butting on it saying "test"?
    If so this is a GFI breaker and it is protecting all the receptacles it feeds. Receptacles in garages and outdoors require this GFCI, or Ground Fault Circuit Interrupter, protection. GFI for short.

    I bet one or more of the receptacle on this circuit got wet and are still wet. Check the outside receptacle and if they are wet simply replace them. They cost about a dollar each and if they are more than several years old and get used replacing them will not be a bad idea at all.
    IMO it's easier than trying to dry them.
    fvajhk's Avatar
    fvajhk Posts: 3, Reputation: 1
    New Member
     
    #3

    Aug 17, 2008, 02:52 PM
    I've changed one that was left open during the storm. It did not do anything. Should I change all of them? If that does not solve the problem, what is my next move?? Thank you again for your kind help.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #4

    Aug 17, 2008, 03:29 PM
    If you can work inside a panel safely, remove wire from GFI breaker to verify it is OK.
    Any junctions that you can separate will help isolate/locate the problem.
    fvajhk's Avatar
    fvajhk Posts: 3, Reputation: 1
    New Member
     
    #5

    Aug 17, 2008, 03:50 PM
    I've never open the panel but willing to give it a try...

    Can you tell me what exactly I need to do and look for in this case? What should I be aware of and be careful of?

    Thank you again...
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #6

    Aug 17, 2008, 04:22 PM
    I would not have you try for liability, An Electrician will work with circuit off, Isolated tools, and remove from breaker. Can't say more. Good Luck.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.



View more questions Search