Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Supporting shower mixing valve when using PEX
[ 4 Answers ]
Can someone provide a few tips for how you support a shower mixing valve in the wall when you've used PEX? On previous showers that I've put in, the copper pipes strapped to a block in the wall was more than enough. This time I can't quite seem to find a decent way to do this. Thanks.
Shower mixing valve leak
[ 2 Answers ]
I am buying a home and during the inspection of the bathroom we noticed that water pours out of the mixing valve for the shower. I was wondering if this requires replacement of the mixing valve or can be repaired in some other way? Can this be done by a do it yourselfer with no plumbing...
Shower mixing valve
[ 4 Answers ]
I have two bthrooms back to back, and all fixtures have ample hot water except one shower mixing valve. It is a temptrol valve. I have replaced the stem twice, replace the seats, cut the water lines in the basement to see if there was a blockage in the piping but cannot seem to find the problem....
Mixing valve/shower arm
[ 2 Answers ]
:cool: Is it possible to install a shower/tub mixing valve on a different wall then the shower arm? We are getting a new house built and if this were possible it would save us a lot of grief... Thanks Doug
Mixing valve reversed
[ 4 Answers ]
Hi, Just completed converting a bathtub to a shower, the new mixing valve for some reason has the hot and cold waters reversed, any suggestions how to fix this, the sink was removed during the remodel and is reversed also but I can just swap the h and c off the faucet knobs, not sure what to do... View more questions Search
|