Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replace 1.5" galvanized steel (male threads) to 4" cast iron stack
[ 1 Answers ]
I need to replace a drain line from an old double cast iron kitchen sink. The existing pipe is 1.5" galvanized steel which threads directly into female threads on a 4" cast iron stack. The male threads of the galvanized pipe broke off in the cast iron. I'm guessing the easiest solution is to...
Adding a PVC "Y" to a underground Cast iron pipe
[ 1 Answers ]
I have a house built in 1962. The cast iron waste pipe runs under the concrete slab in the basement. I have already dug and confirmed the location I want to cut a section out of the pipe and install a "Y" connector and run new plastic waste pipes to a new bath. I have seen PVC connectors that...
Cast Iron: plug stuck in 3" x 1.5" Tee
[ 5 Answers ]
Hey there! I've got a 3" cast iron soil stack, with a 1 1/2" Tee fitting which has a plug in it. There's some goop at the joint, it's pretty hard. Not quite JB-weld hard, but hard. It's beige colored. There's not a lot of room in the space, but I've gotten an 18" pipe wrench on it and i...
PVC to Cast iron "Speed bump"
[ 1 Answers ]
Hello all, I call this thread the speed bump because when I dug out my basement floor to replace an upstream section of cast iron pipe with new pvc pipe for a bathroom and to move my stack, the downstream attachemtn to the cast iron pipe is now giving me some mild trouble. The cross section of...
Shower flange"cast iron"
[ 3 Answers ]
I have a stand alone shower on a slab foundation that leaked I pulled the floor out and the cast iron flange for the liner is in bad shape and needs to be replaced. How do I go about this and where do I get the parts. View more questions Search
|