Ask Experts Questions for FREE Help !
Ask
    gravelyjram's Avatar
    gravelyjram Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 2, 2008, 03:59 AM
    Fine metal shavings in a peerless transaxle.
    I'm rebuilding a Peerless 2300 transaxle and replacing the gears damaged by the previous owner(s). I've removed much of the metal shavings, but tiny particles still cling to the tranny case. Is it important to get those as well? If so, how can I get them out? I've used a solvent bath and a magnet with limited success.

    Thanks.
    Morrowrj's Avatar
    Morrowrj Posts: 345, Reputation: 22
    Full Member
    		  
    #2

    Aug 4, 2008, 04:40 PM
    I recommend checking this site Jacobsen_Ford_Garden_Tractors : The Best Jacobsen/Ford Group On Yahoo

    There is a lot of information about Peerless trans as well as a factory service manual for you unit.


    Good Luck,
    Morrowrj
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Peerless faucet [ 1 Answers ]

We have a two handled peerless kitchen faucet with sprayer. Water just trickles out and nothing come out of the sprayer. When it is turned on it spits out a little water then there's a clunking noise like when the spayer is used, then after a pause the water flows slow, very slow (2-3 minutes to...

Trouble shoot transaxle [ 2 Answers ]

Hello, dave from Wisconsin, I have , I believe to be a 1993 sears lawn mower with a spicer transmission in it. The model for the lawn mower is-- 502.255090 serial no. 28403837. When I tied putting the lawn mower into any gear the mower would not move, I checked the belts and they're fine , I...

View more questions Search