Ask Experts Questions for FREE Help !
Ask
    jscarpe's Avatar
    jscarpe Posts: 5, Reputation: 1
    New Member
    		  
    #1

    Jul 20, 2008, 02:06 PM
    Hard start kit
    Should a new 2.5ton condenser - located on the roof (50'feet + away) and 3 coil inside - need a hard start kit? I thought hard start kits were for old equipment? Should I ask for a new condenser? THANKS!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jul 20, 2008, 03:31 PM
    A FACTORY hard start kit is a option on all units. It can be added later if start up difficulties happen.I have factory kits on all my units.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can't start my Poulan chainsaw. Start rope too hard to pull. [ 1 Answers ]

Can't start my chainsaw because the start rope is too hard to pull out. Pulling the rope causes a jerky action.

Weedeater is hard to start [ 2 Answers ]

Model Fl1500 Feather Lite Pull Cord Jerks And Is Hard To Pull However When Spark Plug Is Out Pull Cord Is Easy

16.5 b&s eng. Hard to start [ 1 Answers ]

I have a 16.5 briggs & strattion garden tractor when trying to start the engine it is very hard to spin over ,you have to keep turning starter switch to get to spinning fast enough to start . I have tried two new batteries cleaned all connections and terminals replaced starter, wondered if there is...

Hard start [ 1 Answers ]

The hard start on my carrier ac38cmc030310 is burned out and I'm not sure of how to wire it back in .I had a ac check and the repairman took it out so I did'nt see how the old one was wired also would it work without it. It's only two years old. There is a blue wire from the harness that goes to...

View more questions Search