Ask Experts Questions for FREE Help !
Ask
    benplumber's Avatar
    benplumber Posts: 8, Reputation: 1
    New Member
     
    #1

    Jul 20, 2008, 12:07 PM
    Overhead Fluorescent Light Install
    Okay, I'm not an electrician but I thought I could do general stuff pretty well. I have a two bulb fluorescent light in the kitchen. I tried today to replace it and purchased a 4 light fluorescent. When I took the two light down, there was a two ground wires, two black, two white & two pink. The two ground were together, one black was attached to the black line coming off the ballast, one white was attached to the white line coming off the balast. The remaining white wire was together with the remaining black line. The two pink wires were connected together.

    When I installed the new light and did not change a thing. I connected the ground to the unit (green screw) however there was no ground wire coming from the ballast (there was not one on the original though either)? I connected the white wire to the white wire, black wire to black wire etc etc. No light. I thought with my limited experience that the white & black wire together should be connected to the respective color to complete the four light system and nothing again. Ideas anyone? What the heck is this pink wire??
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Jul 20, 2008, 12:19 PM
    The pink wires probably were once red of three wire cables, and souns like this is a three way switch setup. Do you have at least two switches for this light?

    As long as you re-connected the black and white from the ballast to the original black and white that fed the other light, all the connections are good and tight, and the ballast is good, all should work fine. Can be a loose connection, maybe the breaker tripped and you are not aware, or one of the switches is not in the right position or has failed.

    Sounds like you connected it properly, must be one of the reasons I mentioned, or something similar.

    There should have been a green screw in the package with the new light. The ground wire should be connected to this green screw, which should be driven into a threaded hole found somewhere in the fixture.

    Be sure the fixture is grounded, as not grounding a fluorescent fixture will affect starting and proper operation of the lamps.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Fluorescent light and humidity [ 4 Answers ]

My kitchen ceiling light is known to not work during periods of high humidity. Last year I replaced the sockets that the (2) bulbs get twisted into, and the problem seemed solved. However, during a recent about of high humidity, the two bulbs weren't working once again. Once the humidity...

How do I install an overhead microwave oven? [ 4 Answers ]

It doesn't really matter what brand at this point. I just want to be sure I can do it and have the necessary tools. Many thanks in advance

Fluorescent light will not light on ceiling fan [ 1 Answers ]

I have a model #357630 Renaissance Hampton Bay ceiling fan. For a good 6 months the light would come on all by it's self. Today, I took the canopy down and found that the receiver was burned and melted a little. First I tried to wire it without a receiver, I could get the fan to work but not the...

Fluorescent light fixture [ 4 Answers ]

I have a problem my friend has a fluorescent light fixture when he turn on the lights they stay bright for a while and then they go dim. This is what I did so far I change the Ballast light clips and the blubs but I am still having the same problem. Is there anything I might be over looking ...

Install overhead microwave over [ 1 Answers ]

We are replacing an overhead microwave, the refurbished came with no instructions, How do we install, and what do we need to buy at the home depot first?


View more questions Search