Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Drain line 80 ft long
[ 2 Answers ]
We are opening a bar and there is no drainage at the bar itself. We need to be able to drain an ice bin. We are going to tie into the drain in the kitchen that is 80 ft away. There will have to be two 90 degree turns on the way there. Is this possible?
Tying 2" drain pipe to perpendicular 3" drain line under slap
[ 3 Answers ]
I want to avoid a 90 degree bend under slab. However, I have to reduce from the 2" pipe that drains the WM to the 3" main drain line, and the reducing tee I find has a very small sweep. Do I need to use a reducing combination wye and is there such thing?
Vent for Washing Machine Drain Attached to Existing Drain Line
[ 0 Answers ]
"Current setup for a washing machine has the discharge hose "hooked" into a laundry tub. Tennants would like something more "permanent." The laundry tub has a normal trap followed by a horizontal run of about 2 feet (2" threaded pipe) then "T's" into a vertical drain/vent. The vent line goes...
Can a toilet and a floor drain share a drain line?
[ 1 Answers ]
Hello, Right now we have a main 4" cast iron sewer pipe running under our basement floor. The very last fixture on the run is a toilet. Can I remove the toilet, replace the final 90 degree elbow with a tee and replace the toilet in the same place, then extend the line a couple feet further and...
Secondary Drain Line Re-Routed to Primary Line
[ 2 Answers ]
Hi, I just purchased a newly constructed condo, and it is a construction mess. In particular, there have been numerous leaks from the HVAC secondary drain line (which drains into an interior space), apparently because the HVAC drain lines have no slope. The builder “repaired” the HVAC... View more questions Search
|