Ask Experts Questions for FREE Help !
Ask
    michaelb2008's Avatar
    michaelb2008 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 13, 2008, 08:06 AM
    Husqvarna riding tractor
    I have a Husqvarna YTH20K46 Garden Tractor with 35 hours since new. When I push down on the go forward pedal, it doesn’t go forward or barely tries to move forward but can’t. The book says to replace the motion drive belt. Although that belt feels loose, it’s hard to believe it would need a new belt in 35 hours of use. I have the belt to replace but want to find out if I’m missing a more obvious solution. Could the transmission be low and if so can it be filled without dropping it down from the mower?
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Jul 15, 2008, 07:35 PM
    If it only has thirty five hours on it, I'd be checking for the cause of the belt being worn. Warranty maybe.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Husqvarna Riding Mower [ 3 Answers ]

I have a 2 year old Husqvarna riding mower with a Briggs and Stratton engine. It ran fine until a couple of weeks ago when the engine started running rough and black smoke came out of the front of the mower. Thinking that maybe diesel fuel was put in it, I drained the tank and put in new gas and...

Husqvarna Riding mower - carb problems [ 4 Answers ]

Hello, I have ~2005 Husqvarna riding mower with a Briggs & Stratton Vanguard engine (model #385777), that has started running poorly. The first time this happened I was pretty sure that I had gotten some bad gas... it started missing a little, then progressed to backfiring, and finally noticed...

Craftsman Riding Lawn Tractor [ 1 Answers ]

I have a 21hp Craftsman. When mowing the grass yesterday the tractor suddenly stopped working - the blades stopped turning and the motor cut off. After disengaging the blades the engine started up with no problems. Now - when I attempt to engage the mower - the engine stops entirely. I've...

View more questions Search