Ask Experts Questions for FREE Help !
Ask
    samsu32's Avatar
    samsu32 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 11, 2008, 04:05 PM
    I installed a water softener
    We are on a well after turning the water back on we have 2 facets that have no pressure could this be air in the lines
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Jul 11, 2008, 05:33 PM
    No, but it could be something blocking the line or a valve not turned back on. What kind of pipeing? Where are the valves. More information is needed.
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #3

    Jul 11, 2008, 07:13 PM
    Remove the aerators. Clean them. Re-install them...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New hot water heater installed, but no hot water pressure. Plenty of cold water? [ 11 Answers ]

Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....

Water softener resin clogging water supply lines [ 1 Answers ]

We have a water softener that has a resin filter that has broken numerous times due to surges in water pressure. This time we didn't realize it had broken in time to bypass the softener and avoid getting resin in the lines again. We've already flushed the resin out of the 2 toilets and 2 sinks...

Constant running water noise, old water softener pipes? [ 3 Answers ]

When we bought our house, it came with a decommissioned water softener in the laundry room. The pipes behind it (I'm assuming in and out) were capped off with plastic plugs that toggle back and forth. If you're familiar with Dr. Dolittle, I'd call it a pushmi-pullyu setup. (sorry, I'm an admin, not...

Low water pressure new well pump is it the Water softener? [ 1 Answers ]

Hi, again I called a well service Co. and they replaced my well pump. It was barely functioning. Strangly the pervious install was a 220 volt pump and it was connected to 110, and it worked. That pump was about 20 years old. The new pump is a 110 volt pump. My problem now is occasional...

Hydrogen sulfide in water - due to water softener? [ 9 Answers ]

Hi, I've been trying to determine the source of a rotten eggs smell that was coming from our sinks and shower. At first I thought it was coming from the drains, and that it had to do with the septic system and/or plumbing pipes/vents. However, I have since determined that the source is the...

View more questions Search