Not your question?
Ask your question
View similar questions
Check out some similar questions!
Difference between single phase and 3-phase motors
[ 4 Answers ]
Difference between single phase and 3-phase motors
Change of code regarding recepticles?
[ 6 Answers ]
Last year I ran a subpanel and all wiring to an addition on a house and passed the underwriters inspection. In the process, I learned about calculating the number of wires and switches or outlet's that can be placed in a receptacle box. I was told (by the underwriter) that when you look at a...
How to go from 200Amps/208V/3 phase to 600Amps/480V/3 phase
[ 2 Answers ]
I am starting a business and have equipment that requires 600Amps/480V/3 phase, but the site I want to rent has only 200Amps/208V/3 phase. Is there anything I can do to get the required power on that site? Any equipment I can buy to achieve this goal? I understand it may be costly. Thank you.
Wall recepticles not working
[ 6 Answers ]
This morning one wall of recepticles stopped working. The fridge is on one of them and was on earlier then suddenly stopped. I checked the two GFI's that run in the kitchen (one under the sink and one on the breaker box). How can I figure out what happened? I am not even sure if I know which...
How am I going to size my 3 phase X'mer with 1 phase load using current as reference
[ 3 Answers ]
Hi, I'm Peping: I have 90 pieces of single phase loads with current of 2 Amperes. This will be loaded to a 3 phase transformer, Wye connected having a line to line voltage of 220 Volts. What will be the size of the transformer required for the mentioned loads? Many thanks, Peping View more questions Search
|