Ask Experts Questions for FREE Help !
Ask
    sbsummers's Avatar
    sbsummers Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 30, 2008, 03:01 PM
    Thermostat message of RE CO
    What does it mean when my Hunter energy star model 44110 thermostat has a message on it :"RE CO" while my air conditioner is running.
    progunr's Avatar
    progunr Posts: 1,971, Reputation: 288
    Ultra Member
    		  
    #2

    Jun 30, 2008, 03:06 PM
    It is nothing to worry about, it is what they refer to as "auto recovery mode".

    It just indicates that the difference between the current temp and the next programed setting is larger, and may require the unit to run longer.

    This setting supposedly causes the unit to run a little extra so that when the next programed temp time arrives, it won't have to work so hard to reach the new temp.

    I believe you can disable this function by removing the unit from the wall plate, and locating the switch on the back of the thermostat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Low Battery message on Maple/Chase Thermostat [ 8 Answers ]

I had a "low battery" message flashing on my Maple/Chase 0960T-1 programmable thermostat. When I replaced the batteries the low battery message remained on the display but this time, it was not flashing back and forth and none of the previous settings appeared on the display. None of the switches...

Hunter Thermostat RE CO message [ 6 Answers ]

My Hunter Thermostat 44110 show "RE CO" as a flashing message. What does this mean and what do I do about it?

Replacement of Carrier Heat Pump Thermostat with Honeywell TH6000 series thermostat. [ 4 Answers ]

I have a Carrier Series 50QT Electric heat pump that still uses the original non programmable thermostat. I am trying to replace it with Honeywell TH6000 series programmable thermostat. The wiring on the existing Thermostat as follows: O - White, I am thinking this is the Reversing Valve? Y...

Reset filter message on Honeywell Chronotherm thermostat [ 1 Answers ]

How do you reset the filter message on a Honeywell Chronotherm IV Plus Thermostat?

Hunter thermostat--no AC message [ 1 Answers ]

I have read other questions and answers but still getting no where===While I do get this message---I have also checked with my meter and am getting voltage back through --but a tad more than the 24.6==actually getting about 26.1--other than that I see nothing wrong--but still get the dang NO AC...

View more questions Search